brintos

brintos / linux-shallow public Read only

0
0
Text · 2.0 KiB · 28c1341 Raw
58 lines · plain
1* IMG Multi-threaded DMA Controller (MDC)2 3Required properties:4- compatible: Must be "img,pistachio-mdc-dma".5- reg: Must contain the base address and length of the MDC registers.6- interrupts: Must contain all the per-channel DMA interrupts.7- clocks: Must contain an entry for each entry in clock-names.8  See ../clock/clock-bindings.txt for details.9- clock-names: Must include the following entries:10  - sys: MDC system interface clock.11- img,cr-periph: Must contain a phandle to the peripheral control syscon12  node which contains the DMA request to channel mapping registers.13- img,max-burst-multiplier: Must be the maximum supported burst size multiplier.14  The maximum burst size is this value multiplied by the hardware-reported bus15  width.16- #dma-cells: Must be 3:17  - The first cell is the peripheral's DMA request line.18  - The second cell is a bitmap specifying to which channels the DMA request19    line may be mapped (i.e. bit N set indicates channel N is usable).20  - The third cell is the thread ID to be used by the channel.21 22Optional properties:23- dma-channels: Number of supported DMA channels, up to 32.  If not specified24  the number reported by the hardware is used.25 26Example:27 28mdc: dma-controller@18143000 {29	compatible = "img,pistachio-mdc-dma";30	reg = <0x18143000 0x1000>;31	interrupts = <GIC_SHARED 27 IRQ_TYPE_LEVEL_HIGH>,32		     <GIC_SHARED 28 IRQ_TYPE_LEVEL_HIGH>,33		     <GIC_SHARED 29 IRQ_TYPE_LEVEL_HIGH>,34		     <GIC_SHARED 30 IRQ_TYPE_LEVEL_HIGH>,35		     <GIC_SHARED 31 IRQ_TYPE_LEVEL_HIGH>,36		     <GIC_SHARED 32 IRQ_TYPE_LEVEL_HIGH>,37		     <GIC_SHARED 33 IRQ_TYPE_LEVEL_HIGH>,38		     <GIC_SHARED 34 IRQ_TYPE_LEVEL_HIGH>,39		     <GIC_SHARED 35 IRQ_TYPE_LEVEL_HIGH>,40		     <GIC_SHARED 36 IRQ_TYPE_LEVEL_HIGH>,41		     <GIC_SHARED 37 IRQ_TYPE_LEVEL_HIGH>,42		     <GIC_SHARED 38 IRQ_TYPE_LEVEL_HIGH>;43	clocks = <&system_clk>;44	clock-names = "sys";45 46	img,max-burst-multiplier = <16>;47	img,cr-periph = <&cr_periph>;48 49	#dma-cells = <3>;50};51 52spi@18100f00 {53	...54	dmas = <&mdc 9 0xffffffff 0>, <&mdc 10 0xffffffff 0>;55	dma-names = "tx", "rx";56	...57};58