56 lines · plain
1Toshiba et8ek8 5MP sensor2 3Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device4 5More detailed documentation can be found in6Documentation/devicetree/bindings/media/video-interfaces.txt .7 8 9Mandatory properties10--------------------11 12- compatible: "toshiba,et8ek8"13- reg: I2C address (0x3e, or an alternative address)14- vana-supply: Analogue voltage supply (VANA), 2.8 volts15- clocks: External clock to the sensor16- clock-frequency: Frequency of the external clock to the sensor. Camera17 driver will set this frequency on the external clock. The clock frequency is18 a pre-determined frequency known to be suitable to the board.19- reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor20 is in hardware standby mode when the signal is in the low state.21 22 23Optional properties24-------------------25 26- flash-leds: See ../video-interfaces.txt27- lens-focus: See ../video-interfaces.txt28 29 30Endpoint node mandatory properties31----------------------------------32 33- remote-endpoint: A phandle to the bus receiver's endpoint node.34 35 36Example37-------38 39&i2c3 {40 clock-frequency = <400000>;41 42 cam1: camera@3e {43 compatible = "toshiba,et8ek8";44 reg = <0x3e>;45 vana-supply = <&vaux4>;46 clocks = <&isp 0>;47 clock-frequency = <9600000>;48 reset-gpio = <&gpio4 6 GPIO_ACTIVE_HIGH>; /* 102 */49 port {50 csi_cam1: endpoint {51 remote-endpoint = <&csi_out1>;52 };53 };54 };55};56