30 lines · plain
1Device-Tree bindings for ST IRB IP2 3Required properties:4 - compatible: Should contain "st,comms-irb".5 - reg: Base physical address of the controller and length of memory6 mapped region.7 - interrupts: interrupt-specifier for the sole interrupt generated by8 the device. The interrupt specifier format depends on the interrupt9 controller parent.10 - rx-mode: can be "infrared" or "uhf". This property specifies the L111 protocol used for receiving remote control signals. rx-mode should12 be present iff the rx pins are wired up.13 - tx-mode: should be "infrared". This property specifies the L114 protocol used for transmitting remote control signals. tx-mode should15 be present iff the tx pins are wired up.16 17Optional properties:18 - pinctrl-names, pinctrl-0: the pincontrol settings to configure muxing19 properly for IRB pins.20 - clocks : phandle with clock-specifier pair for IRB.21 22Example node:23 24 rc: rc@fe518000 {25 compatible = "st,comms-irb";26 reg = <0xfe518000 0x234>;27 interrupts = <0 203 0>;28 rx-mode = "infrared";29 };30