45 lines · plain
1Generic Bluetooth controller over USB (btusb driver)2---------------------------------------------------3 4Required properties:5 6 - compatible : should comply with the format "usbVID,PID" specified in7 Documentation/devicetree/bindings/usb/usb-device.yaml8 At the time of writing, the only OF supported devices9 (more may be added later) are:10 11 "usb1286,204e" (Marvell 8997)12 "usbcf3,e300" (Qualcomm QCA6174A)13 "usb4ca,301a" (Qualcomm QCA6174A (Lite-On))14 15 16Also, vendors that use btusb may have device additional properties, e.g:17Documentation/devicetree/bindings/net/marvell-bt-8xxx.txt18 19Optional properties:20 21 - interrupt-names: (see below)22 - interrupts : The interrupt specified by the name "wakeup" is the interrupt23 that shall be used for out-of-band wake-on-bt. Driver will24 request this interrupt for wakeup. During system suspend, the25 irq will be enabled so that the bluetooth chip can wakeup host26 platform out of band. During system resume, the irq will be27 disabled to make sure unnecessary interrupt is not received.28 29Example:30 31Following example uses irq pin number 3 of gpio0 for out of band wake-on-bt:32 33&usb_host1_ehci {34 #address-cells = <1>;35 #size-cells = <0>;36 37 mvl_bt1: bt@1 {38 compatible = "usb1286,204e";39 reg = <1>;40 interrupt-parent = <&gpio0>;41 interrupt-names = "wakeup";42 interrupts = <3 IRQ_TYPE_LEVEL_LOW>;43 };44};45