89 lines · yaml
1# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)2%YAML 1.23---4$id: http://devicetree.org/schemas/net/dsa/marvell,mv88e6060.yaml#5$schema: http://devicetree.org/meta-schemas/core.yaml#6 7title: Marvell MV88E6060 DSA switch8 9maintainers:10 - Andrew Lunn <andrew@lunn.ch>11 12description:13 The Marvell MV88E6060 switch has been produced and sold by Marvell14 since at least 2008. The switch has one pin ADDR4 that controls the15 MDIO address of the switch to be 0x10 or 0x00, and on the MDIO bus16 connected to the switch, the PHYs inside the switch appear as17 independent devices on address 0x00-0x04 or 0x10-0x14, so in difference18 from many other DSA switches this switch does not have an internal19 MDIO bus for the PHY devices.20 21properties:22 compatible:23 const: marvell,mv88e606024 description:25 The MV88E6060 is the oldest Marvell DSA switch product, and26 as such a bit limited in features compared to later hardware.27 28 reg:29 maxItems: 130 31 reset-gpios:32 description:33 GPIO to be used to reset the whole device34 maxItems: 135 36allOf:37 - $ref: dsa.yaml#/$defs/ethernet-ports38 39required:40 - compatible41 - reg42 43unevaluatedProperties: false44 45examples:46 - |47 #include <dt-bindings/gpio/gpio.h>48 #include <dt-bindings/interrupt-controller/irq.h>49 mdio {50 #address-cells = <1>;51 #size-cells = <0>;52 53 ethernet-switch@16 {54 compatible = "marvell,mv88e6060";55 reg = <16>;56 57 ethernet-ports {58 #address-cells = <1>;59 #size-cells = <0>;60 61 ethernet-port@0 {62 reg = <0>;63 label = "lan1";64 };65 ethernet-port@1 {66 reg = <1>;67 label = "lan2";68 };69 ethernet-port@2 {70 reg = <2>;71 label = "lan3";72 };73 ethernet-port@3 {74 reg = <3>;75 label = "lan4";76 };77 ethernet-port@5 {78 reg = <5>;79 phy-mode = "rev-mii";80 ethernet = <ðc>;81 fixed-link {82 speed = <100>;83 full-duplex;84 };85 };86 };87 };88 };89