58 lines · plain
1Micrel PHY properties.2 3These properties cover the base properties Micrel PHYs.4 5Optional properties:6 7 - micrel,led-mode : LED mode value to set for PHYs with configurable LEDs.8 9 Configure the LED mode with single value. The list of PHYs and the10 bits that are currently supported:11 12 KSZ8001: register 0x1e, bits 15..1413 KSZ8041: register 0x1e, bits 15..1414 KSZ8021: register 0x1f, bits 5..415 KSZ8031: register 0x1f, bits 5..416 KSZ8051: register 0x1f, bits 5..417 KSZ8081: register 0x1f, bits 5..418 KSZ8091: register 0x1f, bits 5..419 LAN8814: register EP5.0, bit 620 21 See the respective PHY datasheet for the mode values.22 23 - micrel,rmii-reference-clock-select-25-mhz: RMII Reference Clock Select24 bit selects 25 MHz mode25 26 Setting the RMII Reference Clock Select bit enables 25 MHz rather27 than 50 MHz clock mode.28 29 Note that this option in only needed for certain PHY revisions with a30 non-standard, inverted function of this configuration bit.31 Specifically, a clock reference ("rmii-ref" below) is always needed to32 actually select a mode.33 34 - clocks, clock-names: contains clocks according to the common clock bindings.35 36 supported clocks:37 - KSZ8021, KSZ8031, KSZ8081, KSZ8091: "rmii-ref": The RMII reference38 input clock. Used to determine the XI input clock.39 40 - micrel,fiber-mode: If present the PHY is configured to operate in fiber mode41 42 Some PHYs, such as the KSZ8041FTL variant, support fiber mode, enabled43 by the FXEN boot strapping pin. It can't be determined from the PHY44 registers whether the PHY is in fiber mode, so this boolean device tree45 property can be used to describe it.46 47 In fiber mode, auto-negotiation is disabled and the PHY can only work in48 100base-fx (full and half duplex) modes.49 50 - coma-mode-gpios: If present the given gpio will be deasserted when the51 PHY is probed.52 53 Some PHYs have a COMA mode input pin which puts the PHY into54 isolate and power-down mode. On some boards this input is connected55 to a GPIO of the SoC.56 57 Supported on the LAN8814.58