40 lines · plain
1Analog Devices ADAU17012 3Required properties:4 5 - compatible: Should contain "adi,adau1701"6 - reg: The i2c address. Value depends on the state of ADDR07 and ADDR1, as wired in hardware.8 9Optional properties:10 11 - reset-gpio: A GPIO spec to define which pin is connected to the12 chip's !RESET pin. If specified, the driver will13 assert a hardware reset at probe time.14 - adi,pll-mode-gpios: An array of two GPIO specs to describe the GPIOs15 the ADAU's PLL config pins are connected to.16 The state of the pins are set according to the17 configured clock divider on ASoC side before the18 firmware is loaded.19 - adi,pin-config: An array of 12 numerical values selecting one of the20 pin configurations as described in the datasheet,21 table 53. Note that the value of this property has22 to be prefixed with '/bits/ 8'.23 - avdd-supply: Power supply for AVDD, providing 3.3V24 - dvdd-supply: Power supply for DVDD, providing 3.3V25 26Examples:27 28 i2c_bus {29 adau1701@34 {30 compatible = "adi,adau1701";31 reg = <0x34>;32 reset-gpio = <&gpio 23 0>;33 avdd-supply = <&vdd_3v3_reg>;34 dvdd-supply = <&vdd_3v3_reg>;35 adi,pll-mode-gpios = <&gpio 24 0 &gpio 25 0>;36 adi,pin-config = /bits/ 8 <0x4 0x7 0x5 0x5 0x4 0x437 0x4 0x4 0x4 0x4 0x4 0x4>;38 };39 };40