45 lines · plain
1* ST-Ericsson DB8500 Thermal2 3** Thermal node properties:4 5- compatible : "stericsson,db8500-thermal";6- reg : address range of the thermal sensor registers;7- interrupts : interrupts generated from PRCMU;8- interrupt-names : "IRQ_HOTMON_LOW" and "IRQ_HOTMON_HIGH";9- num-trips : number of total trip points, this is required, set it 0 if none,10 if greater than 0, the following properties must be defined;11- tripN-temp : temperature of trip point N, should be in ascending order;12- tripN-type : type of trip point N, should be one of "active" "passive" "hot"13 "critical";14- tripN-cdev-num : number of the cooling devices which can be bound to trip15 point N, this is required if trip point N is defined, set it 0 if none,16 otherwise the following cooling device names must be defined;17- tripN-cdev-nameM : name of the No. M cooling device of trip point N;18 19Usually the num-trips and tripN-*** are separated in board related dts files.20 21Example:22thermal@801573c0 {23 compatible = "stericsson,db8500-thermal";24 reg = <0x801573c0 0x40>;25 interrupts = <21 0x4>, <22 0x4>;26 interrupt-names = "IRQ_HOTMON_LOW", "IRQ_HOTMON_HIGH";27 28 num-trips = <3>;29 30 trip0-temp = <75000>;31 trip0-type = "active";32 trip0-cdev-num = <1>;33 trip0-cdev-name0 = "thermal-cpufreq-0";34 35 trip1-temp = <80000>;36 trip1-type = "active";37 trip1-cdev-num = <2>;38 trip1-cdev-name0 = "thermal-cpufreq-0";39 trip1-cdev-name1 = "thermal-fan";40 41 trip2-temp = <85000>;42 trip2-type = "critical";43 trip2-cdev-num = <0>;44}45