145 lines · plain
1===========================================================================2Proper Locking Under a Preemptible Kernel: Keeping Kernel Code Preempt-Safe3===========================================================================4 5:Author: Robert Love <rml@tech9.net>6 7 8Introduction9============10 11 12A preemptible kernel creates new locking issues. The issues are the same as13those under SMP: concurrency and reentrancy. Thankfully, the Linux preemptible14kernel model leverages existing SMP locking mechanisms. Thus, the kernel15requires explicit additional locking for very few additional situations.16 17This document is for all kernel hackers. Developing code in the kernel18requires protecting these situations.19 20 21RULE #1: Per-CPU data structures need explicit protection22^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^23 24 25Two similar problems arise. An example code snippet::26 27 struct this_needs_locking tux[NR_CPUS];28 tux[smp_processor_id()] = some_value;29 /* task is preempted here... */30 something = tux[smp_processor_id()];31 32First, since the data is per-CPU, it may not have explicit SMP locking, but33require it otherwise. Second, when a preempted task is finally rescheduled,34the previous value of smp_processor_id may not equal the current. You must35protect these situations by disabling preemption around them.36 37You can also use put_cpu() and get_cpu(), which will disable preemption.38 39 40RULE #2: CPU state must be protected.41^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^42 43 44Under preemption, the state of the CPU must be protected. This is arch-45dependent, but includes CPU structures and state not preserved over a context46switch. For example, on x86, entering and exiting FPU mode is now a critical47section that must occur while preemption is disabled. Think what would happen48if the kernel is executing a floating-point instruction and is then preempted.49Remember, the kernel does not save FPU state except for user tasks. Therefore,50upon preemption, the FPU registers will be sold to the lowest bidder. Thus,51preemption must be disabled around such regions.52 53Note, some FPU functions are already explicitly preempt safe. For example,54kernel_fpu_begin and kernel_fpu_end will disable and enable preemption.55 56 57RULE #3: Lock acquire and release must be performed by same task58^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^59 60 61A lock acquired in one task must be released by the same task. This62means you can't do oddball things like acquire a lock and go off to63play while another task releases it. If you want to do something64like this, acquire and release the task in the same code path and65have the caller wait on an event by the other task.66 67 68Solution69========70 71 72Data protection under preemption is achieved by disabling preemption for the73duration of the critical region.74 75::76 77 preempt_enable() decrement the preempt counter78 preempt_disable() increment the preempt counter79 preempt_enable_no_resched() decrement, but do not immediately preempt80 preempt_check_resched() if needed, reschedule81 preempt_count() return the preempt counter82 83The functions are nestable. In other words, you can call preempt_disable84n-times in a code path, and preemption will not be reenabled until the n-th85call to preempt_enable. The preempt statements define to nothing if86preemption is not enabled.87 88Note that you do not need to explicitly prevent preemption if you are holding89any locks or interrupts are disabled, since preemption is implicitly disabled90in those cases.91 92But keep in mind that 'irqs disabled' is a fundamentally unsafe way of93disabling preemption - any cond_resched() or cond_resched_lock() might trigger94a reschedule if the preempt count is 0. A simple printk() might trigger a95reschedule. So use this implicit preemption-disabling property only if you96know that the affected codepath does not do any of this. Best policy is to use97this only for small, atomic code that you wrote and which calls no complex98functions.99 100Example::101 102 cpucache_t *cc; /* this is per-CPU */103 preempt_disable();104 cc = cc_data(searchp);105 if (cc && cc->avail) {106 __free_block(searchp, cc_entry(cc), cc->avail);107 cc->avail = 0;108 }109 preempt_enable();110 return 0;111 112Notice how the preemption statements must encompass every reference of the113critical variables. Another example::114 115 int buf[NR_CPUS];116 set_cpu_val(buf);117 if (buf[smp_processor_id()] == -1) printf(KERN_INFO "wee!\n");118 spin_lock(&buf_lock);119 /* ... */120 121This code is not preempt-safe, but see how easily we can fix it by simply122moving the spin_lock up two lines.123 124 125Preventing preemption using interrupt disabling126===============================================127 128 129It is possible to prevent a preemption event using local_irq_disable and130local_irq_save. Note, when doing so, you must be very careful to not cause131an event that would set need_resched and result in a preemption check. When132in doubt, rely on locking or explicit preemption disabling.133 134Note in 2.5 interrupt disabling is now only per-CPU (e.g. local).135 136An additional concern is proper usage of local_irq_disable and local_irq_save.137These may be used to protect from preemption, however, on exit, if preemption138may be enabled, a test to see if preemption is required should be done. If139these are called from the spin_lock and read/write lock macros, the right thing140is done. They may also be called within a spin-lock protected region, however,141if they are ever called outside of this context, a test for preemption should142be made. Do note that calls from interrupt context or bottom half/ tasklets143are also protected by preemption locks and so may use the versions which do144not check preemption.145